SEG Backlit Pop Up Replacement Fabric

Keep the frame, change the graphic

The frame, LED bars, drivers and case on a backlit pop up media wall outlast any one campaign. When the branding changes, you reorder the printed fabric and keep everything else — a fraction of the cost of a new stand, and nothing new to store.

What one order covers

One printed face plus both 35mm side returns. If you are re-skinning the front and the back, order two. If only one face has changed — or one panel has been scuffed — order one and leave the rest as they are.

The 6m prints as one piece

A 6m wall is two 3m frames joined, but the graphic is printed as one continuous piece across the join. Artwork that runs the full width — a headline, a product shot, a horizon — stays unbroken instead of being cut in half down the middle of the stand.

Custom sizes and other brands' frames

Any dimension is made to order, including replacement skins for a pop up frame bought somewhere else. SEG channel and welt sizes vary between manufacturers, so send us the frame brand, the panel size and a photo of the channel and we will confirm the fit before you order rather than after.

Related

This is the printed graphic only. For the complete display, see the SEG Backlit Pop Up Media Wall. For replacement skins for a flat SEG backlit lightbox rather than a pop up frame, see the SEG Backlit Lightbox Replacement Fabric.

What exactly do I get in one order?

One printed face plus both 35mm side returns. To re-skin the front and the back of the wall, order two. This is the printed fabric only — no frame, LED bars, drivers or case.

Will it fit the frame I already own?

If the frame came from us, yes — order the same size you bought. If it came from another supplier, send us the frame brand, the panel size and a photo of the channel. SEG channel and welt profiles vary between manufacturers, so we confirm the fit before printing rather than after.

Can I order a size that is not listed?

Yes. Any dimension is made to order. Send us the finished panel size and we will quote it — call 1300 197 088 or use the contact page.

Is the 6m graphic printed in one piece or two?

One continuous piece. The 6m wall is two 3m frames joined, but the graphic runs unbroken across the join, so artwork spanning the full width is not cut in half down the centre of the stand.

What fabric is it printed on?

Premium blockout backlit fabric, dye-sublimation printed full colour edge to edge, with a silicone welt sewn around the perimeter. The blockout layer keeps the light inside the panel so the print stays punchy rather than washed out.

How do I fit it?

Pull the old graphic out of the channel by the welt, then push the new one in by hand, working around the frame. It pulls drum tight with no tools, no velcro and no visible fixings. A panel takes a couple of minutes.

How long does it take?

7–8 working days from artwork approval, plus freight — freight time depends on your state. We proof your file before anything goes to print.

Can I wash a graphic instead of replacing it?

For marks, spot-clean gently with cold water and a damp sponge, then dry in the shade — not in direct sun or a dryer. Reinsert it into the channel while slightly damp to pull out any creases. Replace it when the print is damaged, faded or the branding has changed.